Housing Components - Mazda MX-5 1990 Workshop Manual

DISASSEMBL Y
Precaution
TRANSMISSION
J
1. Clean the transmission exterior thoroughly with a steam cleaner ·or cleaning solvent before disassembly.
2. Clean the removed parts (except sealed bearings) and all sealing surfaces with cleaning solvent, and dry
with compressed air.
Clean out all holes and passages with a compressed air, and check that there are no obstructions.
3. Wear eye protection when using compressed air to clean components.
Housing Components
Note
• Do not remove the front and rear oil seals if not necessary.
Disassemble in the order shown in the figure, referring to Disassembly Note.
1
)
8
REPLACE
CVSELESTIVE
@REPLACE
5
REPLACE
1. Release bearing
2.
Release fork
3. Boot
4. Front cover
5. Gasket
6. Oil seal (front)
I nspect for damage of oil
seal lip. If necessary, re-
place it.
7. Adjustment shim
8. Snap ring
9. Speedometer driven gear
1 O. Neutral switch
11. Back-up light switch
12. Extension housing
Disassembly Note
....................... page J-14
Disassembly ..... page J-22
13. Transmission case
Disassembly Note
....................... page J-14
05UOJX-011
14.
Snap rings
15. Speedometer drive gear
16. Steel ball
17. Oil seal (rear)
Inspect for damage of oil
seal lip
If necessary, replace it.
Replace (on-vehicle)
....................... page J-14
J-13