Mazda MX-5 1990 Workshop Manual page 717

BLUI; CONNECTOR
AIR BAG SYSTEM
T
ALIGNMENT MARKS
05UOTX-360
05UOTX-361
05UOTX-362
05UOTX-363
4. Align the marks on the clock spring connector
and the outer housing.
6. When Using Test Lead
• When using a test lead for testing, use a fine nee-
dle to prevent damage to the terminal.
7. Disconnecting Double Lock Type Connector
• The connectors in the air bag system use a double
lock type connector.
• These connectors are disconnected as below.
1) Press the orange knob and disconnect the orange
connector.
2) Press the blue knob and disconnect the blue con-
nector.
3) Connect the connectors in the reverse order of
disconnecting.
8. After System Service
• After system service verify system operation by
checking with the air bag system warning lamp.
If the system is operating normally, the warning
lamp will come on when the ignition switch is turned
ON, then go off after approximately 6 seconds.
• Check if the horn sounds. If the horn does not
sound, remove the air bag module and check the
connections of the air bag module and horn switch
connectors.
T-135