Mazda MX-5 1990 Workshop Manual page 412

DIFFERENTIAL MOUNTING SPACER
05UOMX-125
PPF
SLEEVE
JPm---. :
BLOCK
BOLT (M6x1)
BOLT (M14x1.5)
05UOMX-070
Q
o
05UOMX-071
05UOMX-073
DIFFERENTIAL
M
5. Remove the differential mounting spacer .
..
6. Turn a bolt (M 14x1.5) into the sleeve.
7. Twist and pull the bolt downward.
S. Install a bolt (M6x1) into the hole in the block to hold the
sleeve, and remove the long bolt (M14x1.S).
9. Remove the bolt (M6x1).
Caution
• Do not remove the spacers shown in the figure from
the PPF.
• If they are removed, repalce the PPF as an as-
sembly.
10. Remove the transmission-side bolts, and remove the PPF.
Driveshaft
Mark the driveshaft and output shaft for proper installation.
Differential
1. Support the differential with a jack.
2. Down and move it forward.
Note
• If it is difficult to separate the driveshaft from the
output shaft, remove one side upper arm installa-
tion bolt and nut.
3. Separate the driveshaft from the output shaft.
M-29