Actuator Cable - Mazda MX-5 1990 Workshop Manual

T
T-106
CRUISE CONTROL SYSTEM
05UOTX-460
11
b
a
05UOTX-229
ACTUATOR CABLE
Removal
1. Disconnect the actuator cable from the accelerator pedal.
2. Remove the clamp at the inside of the firewall.
3. Disconnect the actuator cable from the actuator.
4. Remove the clamps and the actuator cable.
Installation
Install in the reverse order of removal.
Adjustment
Remove the clamp and adjust the nut so that actuator cable
free play is as shown when the cable is pressed lightly.
Cable play: 1-3mm (0.04-0.12 in)
CLUTCH SWITCH
Removal
Loosen the locknut and remove the switch.
Installation
Install in the reverse order of removal.
Adjustment
Adjust the switch to set the specified pedal height.
Pedal height: 175-185mm (6.89-7.82 in)
Pedal freeplay: 0.6-3.1 mm (0.02-0.12 in)
Inspection
1 . Disconnect the clutch switch connector.
2. Check continuity between terminals of the switch.
Pedal position
Terminal
a b
Pedal released
Pedal depressed 0 {)
o--D:
Indicates continuity
3. If not as specified, replace the clutch switch.
- --- ___
-~--~-.----------_t----__r_-------I--.,---------------