WINDOW REGULATOR, GLASS, AND GUIDE
3. Fore and aft adjustment of side edge of door glass
Adjustment procedure
s
Remove the weatherstrip, and check alignment with the door glass in the fully-closed position.
(1) Loosen window regulator installation nuts (0) and glass gUide installation nut (E).
(2) Adjust by moving the window regulator and the glass guide fore or aft equally so that the side edge
of the door glass is in the correct position, and then tighten the nuts (0) and (E).
Note
• The window regulator and glass guide should be tightened in approximately the same posi-
tion in the slotted adjustment holes.
• The door glass must raise and lower smoothly with the door closed.
SEC. B-B
GLASS GUIDE
DETACHABLE HARD TOP
CONVERTIBLE TOP
RETAINER MOUNTING HOLE No.5
RETAINER MOUNTING HOLE No.1
15 (0.59)
®E
E
~ETAINER
MOUNTING HOLE No.7
jfTAINER MOUNTING HOLE
NO.:
E
65 (2.56)
~RETAINER
MOUNTING HOLE No.3
F
F
RETAINER MOUNTING HOLE NO.5
RETAINER MOUNTING HOLE NO.6
©
16 (0.62)
d
©
12.5
±
2.0 (0.49
±
0.08)
@
SEC. E-E
SEC. F-F
12.0
±
2.0 (0.47
±
0.08)
mm (in)
05UOSX-016
8-13