Differential Oil; Oil Seal (Output Shaft) - Mazda MX-5 1990 Workshop Manual

M
9MUOMX-033
05UOMX-057
M-24
DIFFERENTIAL
DIFFERENTIAL OIL
Inspection
1. Remove the filler plug.
2. Verify that the oil is at the bottom of the filler plug hole.
If it is low, add the specified oil.
.3. Install the filler plug.
Tightening torque:
39-54 N·m (4.0-5.5 m-kg, 29-40 ft-Ib)
Replacement
1. Remove the filler and drain plugs.
2. Drain the differential oil into a suitable container.
3. Wipe the plugs clean.
4. Install the drain plug and washer.
Tightening torque:
39-54 N·m (4.0-5.5 m-kg, 29-40 ft-Ib)
5. Add the specified oil from the filler plug until the level reaches
the bottom of the plug hole.
Specified oil
Type:
Above -18°C
(OOF):
API GL-5, SAE 90
Below -18°C (O°F): API GL-5, SAE BOW
Capacity: 0.65 liter (0.69 US qt, 0.57 Imp qt)
6. Install the filler plug.
Tightening torque:
39-54 N·m (4.0-5.5 m-kg, 29-40 ft-Ib)
OIL SEAL (OUTPUT SHAFT)
Replacement
1. Jack up the vehicle and support it with safety stands.
2. Drain the differential gear oil.
Note
• Mark the driveshaft and output shaft flanges for
proper reassembly.
3. Remove the upper arm installation bolt and nut.