Mazda MX-5 1990 Workshop Manual page 456

BRAKE SYSTEM
p
Removal/Inspection /Installation
1. Remove in the order shown in the figure.
2. Inspect all parts and repair or replace as necessary.
3. Install in the reverse order of removal.
4. After installation, check and adjust the pedal height and free play if necessary.
Caution
• Apply grease to the inner surface of the bushing and to the contact surfaces of the clevis pin
and spring.
1. Spring clip
2. Clevis pin
3. Nut
4. Spring washer
5.
Bolt
6.
Return spring
Inspect for weakness and
damage
7. Brake pedal
Inspect for bending
8. Guide pipe
N·m (m-kg, ft-Ib)
9. Bushing
I nspect for wear
10.
Stopper rubber
Inspect for wear
11 . Pedal pad
05UOPX-015
Inspect for wear and damage
P-9