Mazda MX-5 1990 Workshop Manual page 404

Hide thumbs Also See for MX-5 1990:

Table of Contents

3. Align the marks, then install a new clip.

• Be sure the boot is not dented or twisted.

• Carefully lift up the small end of the boot to release

any trapped air.

1. Set the boots onto the rings.

2. Measure the driveshaft length.

Standard length:659. 7-669. 7mm (25.972-26.366 in)

If not within specification, return to Step 1.

• Standard length (On-vehicle): 659.3mm (25.957 in)

• Always use a new band.

• The band should be folded in the direction oppo-

site the forward revolving direction of the driveshaft.

3. Fold the band back by pulling on the end of it with pliers.

4. Lock the end of the band by bending the locking clips.

Show Quick Links

Table of Contents

Troubleshooting