Clutch Cover And Disc; Pilot Bearing; Flywheel - Mazda 121 Workshop Manual

CLUTCH UNIT
Rgmoval Note
Outch cover and disc
1. lnstall the ssT.
Caution
. Put 8pacs6 between the (49 E30l 060)andlhecyl-
inder block, setling dimeaion @ as shown in the
figure io l3mm (0.51 in). (Except 83 ATX)
2. Loosen each bolt one turn at a time in a crisscross Dattern
until spring tension is released. Then remove the clutch cov-
er and disc.
Pilot bearing
Remove the pilot bearing with the SST if necessary.
Flywheel
Note
. After removlng the lly'rvheel, Inspeci lor oil leakage
pasl the crankshatt rear oil seal,
lf ngcess€ry, replace the oil seal.
(Rete. lo Seclion B.)
1. Hold the flywheel with the SST.
2. Remove the bolts in the sequence shown in the figure in
steos.
3. Remove the tlywheel.
H-9