After-Repair Procedure - Mazda MX-5 1990 Workshop Manual

F
F-88
SELF-DIAGNOSIS FUNCTION
~---=::
.....
SELECT SW A
- . \ TEST SW
--=~r=-..:02 MONITOR
05UOFX-093
After-repair Procedure
1. Cancel the memory of malfunctions by disconnecting the
negative battery cable and depressing the brake pedal for
at least five seconds.
Reconnect the negative battery
cable.
2. Connect the SSTs to the diagnosis connector as shown.
3. Turn the ignition switch ON, but do not start the engine for
six seconds.
4. Start and warm up the engine, then run it at 2,000 rpm for
three minutes.
5. Verify that no code numbers are displayed.