Chapter 9: Configuration
Contacts
Editing the Fibre Channel Port Type
Edit the port type to change the mode of a Fibre Channel port to initiator or target mode. You can change the
port mode only on inactive connections:
Additional Information
Before changing a Fibre Channel port type from initiator to target, unplug the Fibre Channel port wire
l
connection.
Before changing a Fibre Channel port type from target to initiator, un-map any host mapping on the
l
Fibre Channel port, and unplug the Fibre Channel port wire connection.
To edit the Fibre Channel Port type:
1. Select the port in the list and click Edit.
2. Select the new port mode (Initiator or Target) in the drop-down box,
3. Click Update.
Contacts
The Contacts page allows you to enter company information. You can also enter individual contact
information for primary and secondary contacts.
To access the Contacts page, click the Configuration menu, and then click the Contacts tab.
The Contacts page contains the following tabs:
Company below
l
Primary and Secondary on the next page
l
Company
The Company page allows you to enter information about the company and location of the DXi6900.
To access the Company page, on the Contacts page, click the Company tab (see
page).
Quantum DXi6900 User's Guide
Figure 225 on the next
352