Quantum DXi6900 User Manual page 97

Chapter 4: Configuration Wizards
Replication Wizard
Step 1: About
1. Read the information about the wizard.
2. Click Next to continue.
Note: At any time while using the wizard, you can click Previous to return to the previous step (see
Figure 58 below).
Figure 58: Replication Wizard: About
Step 2: System
1. If data on this DXi6900 will be replicated to another DXi system, enter target information under Target
DXis (see Figure 59 on page
If two targets are already specified, you must delete a target before adding another. First click Pause to
pause replication to the target, and then click Delete to remove the target.
Before specifying a target, make sure you have completed the Replication wizard on the target DXi.
The target DXi must be configured to allow the source DXi hostname or IP address.
You can specify up to two targets:
a. In the Target Hostname or IP Address box, enter the hostname or IP address of the system that
will receive the replicated data.
When entering IP addresses, never use an address that is in a reserved IP address range. To see
a list of reserved IP address ranges, click the quick tip icon [?] located near the IP address field.
To use hostname format, you must specify at least one DNS IP address on the Network page (see
Network on page
b. (Optional) Select an encryption option:
Quantum DXi6900 User's Guide
99).
305).
97