Quantum DXi6900 User Manual page 243

Chapter 9: Configuration
VTL Configuration
If you do not see the world wide name (WWN) of the host, make sure the host is connected to a Fibre
Channel port on the DXi6900 and click Discover Hosts again.
The Backpanel Locations section displays a graphical representation of the Fibre Channel and
Ethernet ports as they appear on the rear of the system.
Note: A mapped (green) status indicates the host is currently logged on to one or more Fibre
Channel target ports.
2. Enter information about the host:
Remote Host WWPN
Alias
3. Click Apply.
Note: To delete a host that is no longer needed, click Delete next to the host. You cannot delete a host
of it is currently assigned to a host access group
Targets
Use the Targets page to view the current target (Fibre Channel) configuration.
To access the Targets page, on the Host Access page, click the Targets tab (see
Figure 155 on the next
Figure 154: DXi6900 G1 Targets Page
Quantum DXi6900 User's Guide
Enter the World Wide Port Name (WWPN) of the host. (This value is entered
automatically by the system.)
(Optional) Enter a descriptive alias for the host.
page).
Figure 154 below and
243