Quantum DXi6900 User Manual page 315

Chapter 9: Configuration
System
Dest Netmask
Dest Gateway
Example 3: Segments on the Same Subnet and Target on a Different Subnet
In the example below (see
management traffic, and one for replication traffic:
The source DXi management/data IP address and the source DXi replication IP address are on the same
l
subnet (192.168.10.x). The target DXi IP address is on a different subnet (192.168.20.x)
To make sure the replication segment is used when communicating with the target DXi, you must add a
l
network route in the Routing Details section on the source DXi.
In this example, you would specify the following routing details for the replication interface on the source
DXi:
Destination
Dest Netmask
Dest Gateway
In addition, to enable communication with the target DXi by means of the gateway, you must add a
l
second host route in the Routing Details section on the source DXi.
In this example, you would specify a second set of routing details for the replication interface on the source
DXi:
Destination
Dest Netmask
Dest Gateway
Quantum DXi6900 User's Guide
Use 255.255.255.255.
Use the replication IP address of the source DXi (192.168.10.100).
on page 305), the DXi has two segmented interfaces, one for data and
Use the subnet of the target DXi (192.168.20.0).
Use 255.255.255.0.
Use the IP address of the gateway (192.168.10.1).
Use the IP address of the gateway (192.168.10.1).
Use 255.255.255.255.
Use the replication IP address of the source DXi (192.168.10.100).
315