Contacts Configuration - Quantum DXi4500 User Manual

Contacts Configuration

Quantum DXi4500 User's Guide
5 Select the Community Status check box to enable this SNMP
community.
6 Click Apply.
An Information page displays indicating the community has been
added.
Test
Use the Test page to send a test SNMP trap.
To send a test SNMP trap:
1 From the SNMP page, click the Test tab.
2 Select an SNMP destination.
3 Click Send to send a test SNMP trap.
The test trap is sent. Verify the destination to ensure the SNMP trap
was sent.
Use the Contacts page to enter company contact information.
To access the Contacts page:
1 From the Configuration menu, click the Contacts tab.
The Company Information page displays (see
Chapter 5: DXi4500 Configuration
Contacts Configuration
Figure 40).
107