Replication Configuration - Quantum DXi6900 User Manual

Chapter 9: Configuration

Replication Configuration

To configure DXi Accent:
1. To enable DXi Accent, select the Enable Deduplication with Accent check box.
Or to disable DXi Accent, clear the Enable Deduplication with Accent check box.
Note: You cannot use DXi Accent if you are currently using NetBackup Accelerator or Optimized
Synthetic Backups. If you are using Accelerator, please make sure that Accent is not enabled. For
more information on using NetBackup Accelerator, see the DXi-Series Configuration and Best
Practices Guide for NetBackup from Veritas (6-67850).
2. Click Apply.
Additional Information
Click the Change Encryption Type link to change the OST data encryption type (see
l
Encryption on page
To use DXi Accent, you must install the Quantum OST Client Plug-in on the media server. For
l
information about installing the OST Plug-in and using DXi Accent, see the DXi-Series NetBackup
and Backup Exec OST Configuration Guide (6-67079).
Replication Configuration
The Replication Configuration page allows you to configure and manage replication targets and allowed
replication sources on the DXi6900. A source sends replicated data to 1 or 2 targets, and a target receives
replicated data from up to 10 sources. A DXi6900 can act as both a source and a target.
Additional Information
For more information about data replication, or to perform data replication, see
l
130.
If the DXi is configured as a replication target and replication is performed across a public network,
l
with the source and target located behind NAT-enabled routers, you must specify a NAT IP address
for the DXi on the Network page (see
To access the Replication Configuration page, click the Configuration menu, and then click the
Replication tab (see Figure 167 on the next
Quantum DXi6900 User's Guide
338).
Configuring Interface IP Addresses on page
page).
Data
Replication on page
309).
268