Quantum DXi6900 User Manual page 101

Chapter 4: Configuration Wizards
Replication Wizard
Figure 60: Replication Wizard: NAS Shares
Step 4: VTL Partition
1. Select a VTL partition in the Replication Settings for VTL Partitions section to manage its
replication settings (see
Note: For help adding VTL partitions to the system, use the VTL Configuration Wizard (see
Wizard on page
2. To configure the partition to replicate its data to another DXi system, enter the following information
under Send:
a. Select the Enable replication for selected partition check box to enable replication for the
partition.
b. (Optional) Select the Enable Cartridge based replication to target check box to enable
Cartridge Based Replication for the partition, and then enter a Sync ID in the box.
With Cartridge Based Replication, a cartridge is automatically replicated when it is unmounted.
After replication, the replicated cartridges are immediately available on the target system.
The Sync ID is used to identify the target partition that will receive replicated data from the source
partition. The Sync ID must be identical to the Sync ID of the target partition on the target system.
c. Select the check box for each replication target you want to replicate the partition to. When the
partition is replicated, its data will be sent to all selected targets.
3. To configure the partition to receive replicated data from another DXi system, enter the following
information under Receive:
Quantum DXi6900 User's Guide
Figure 61 on the next
83).
page).
VTL
101