Quantum DXi6900 User Manual page 311

Chapter 9: Configuration
System
Note: If the DXi6900 is a replication target and is behind a NAT router, you must configure a NAT
IP Address
NATed
NAT IP Address
6. Select the check box for each type of network traffic allowed on the interface (segmentation):
At least one interface must allow management traffic.
Mgmt Select to allow management traffic.
Repl Select to allow replication traffic.
Data Select to allow data traffic.
Any Select to allow all types of traffic (management, replication, and data).
Additional Information
At least one interface must allow management traffic.
l
If the DXi is configured for source or target replication, you should configure at least one interface
l
to allow replication traffic (select Repl or Any) before applying changes to network settings.
If you configure segmentation for non-bonded interfaces (Ethernet ports) that are on the same
l
subnet, all traffic will use the lowest numbered Ethernet port first, no matter how segmentation is
configured. To avoid this issue, create bonded interfaces, and then select the desired traffic type
for each bonded interface.
7. Click Update to save the changes you made to the IP Address table. (Clicking Update does not yet
apply the new network settings to the DXi6900.)
8. Click Delete to remove IP address information for the selected interface. Or click Undo to revert all
current IP Address Table changes to the last update.
Quantum DXi6900 User's Guide
Select the check box if the IP address of the DXi is translated by a firewall to a NAT
IP address when the DXi communicates to the outside world.
The IP address used to access the DXi from the public network. The router that
connects the DXi to the Internet performs Network Address Translation that maps
the IP address of the DXi to the NAT IP address, providing a valid replication
interface for a source DXi.
311