Quantum DXi6900 User Manual page 272

Chapter 9: Configuration
Replication Configuration
When configuring segmented network interfaces, if the source DXi replication, data, and
l
management interfaces are on the same subnet, you must add a host route on the source DXi to
make sure the replication interface is correctly selected when replicating data to the target DXi
(see Understanding Interface Routing on page
5. Click Apply.
Note: The new target is not automatically added to existing replication schedules. You must add or edit
scheduled events to schedule replication to the new target (see
Editing a Replication Target
Edit a replication target to change encryption options or the source IP address.
To edit a replication target:
1. Under Target DXis , select the target and click Pause to pause replication.
2. Select the target again and click Edit.
The Edit Target Host window displays (see
Note: If you are editing a target, you cannot change the Target Hostname or IP.
Figure 169: Edit Target Host
3. In the Encryption drop-down box, select the type of encryption to use when sending replication data to
the target system (None, 128-bit, or 256-bit).
Caution: For encryption, select None or 128-bit if you are sending data to a DXi running a system
software version prior to DXi 2.1 Software.
Note: AES encryption options are available only if the Data-in-Flight license is installed (see
License Keys on page
4. In the Source IP Address box, enter the IP address that is used to uniquely identify the source DXi to
the target. This may be different than the actual network IP address of the source DXi.
If the target system is at DXi 2.1 Software or higher, the Source IP Address field is not required. If the
target system is at DXi 2.0.1.x Software or below, then you must enter the IP address by which the
target system recognizes the source system. The default value is 0.0.0.0.
Quantum DXi6900 User's Guide
Figure 169
366).
313).
Scheduler on page
below).
279).
272