Quantum DXi6900 User Manual page 362

Chapter 10: Utilities
Analyzer
Figure 233: Performance Page
To perform network analysis:
1. In the Target IP Address box, enter the IP address of the system to perform network analysis with.
The target system must have NetServer enabled (see
2. Click Start.
The throughput result is displayed under Result From Last Run in MB/s.
Note: It takes approximately 5 seconds to refresh the results.
Settings
The Settings page allows you to enable or disable NetServer on the DXi6900. NetServer must be enabled
on the target DXi6900 system to perform network analysis with the system (see
previous page).
To access the Settings page, on the Network Analyzer page, click the Settings tab (see
below).
Figure 234: Settings Page
To enable or disable NetServer on the target DXi6900:
1. Select Enable NetServer to enable NetServer.
Or select Disable NetServer to disable NetServer.
Quantum DXi6900 User's Guide
Settings below).
Performance on the
Figure 234
362