Quantum DXi6900 User Manual page 314

Chapter 9: Configuration
System
Because this host is not on the same subnet as the data interface, the DXi cannot communicate with the
host unless you specify routing information in the Routing Details section.
In this example, you would specify 10.50.50.0 for destination network, 255.255.255.0 for the destination
netmask, and 10.20.20.1 as the destination gateway.
Note: The gateway specified in the IP Address Table section is for incoming traffic to the interface.
The gateway specified in the Routing Details section is for outgoing traffic from the interface.
Example 2: Segments and Target on the Same Subnet
In the example below (see
management traffic, and one for replication traffic:
The source DXi management/data IP address, the source DXi replication IP address, and the target DXi
l
IP address are all on the same subnet (192.168.10.x).
To make sure the replication segment is used when communicating with the target DXi, you must add a
l
host route in the Routing Details section on the source DXi.
In this example, you would specify the following routing details for the replication interface on the source
DXi:
Destination
Quantum DXi6900 User's Guide
on page 305), the DXi has two segmented interfaces, one for data and
Use the IP address of the target DXi (192.168.10.200).
314