Quantum DXi6900 User Manual page 302

Chapter 9: Configuration
Notifications
agent is accessible from any IP address.
When entering IP addresses, never use an address that is in a reserved IP address range. To
l
see a list of reserved IP address ranges, click the quick tip icon [?] located near the IP address
field.
4. In the Access Type drop-down box, select the access type for the community:
Get
Get/Set
5. Select the Community status check box to enable the community.
Or clear the Community status check box to disable the community.
6. Click Apply.
Editing a Community
Edit an SNMP community to change the IP address or access type for the community. You can also enable
or disable the community.
To edit a community:
1. Click Edit.
The Edit SNMP Community page displays (see
Figure 188: Edit SNMP Community Page
2. (Optional) In the Name box, select a different community to edit.
3. Enter a valid IP Address and Network Mask pair.
A pair is valid if performing a logical bitwise AND operation on the IP address and the network mask
results in the IP address. See the table below for examples:
Quantum DXi6900 User's Guide
Allows SNMP get operations.
Allows both SNMP get and put operations.
Figure 188 below).
302