Performing Initial Configuration; Completing The Getting Started Wizard - Quantum DXi6902 Installation And Configuration Manual

Performing Initial Configuration

Completing the Getting
Started Wizard
Performing Initial Configuration
Software successfully initialized.
Run 'Finalize PTO' option.
14 On the Pick to Order Menu, type the option for Finalize PTO and press <Enter>.
The system displays the following message:
PTO is now Disabled.
Reboot to start the DXi stack [y/n]?
15 Type y and press <Enter>.
The system disables PTO Mode and automatically reboots. Wait for the system to
boot before continuing with initial configuration. (This can take up to 30 minutes.)
Before the DXi6902 is operational, you must configure the system through the remote
management console. You must also configure your backup software.
Configuring the DXi6902 consists of four major steps. See the following subsections for
detailed instructions for completing each step:
1

Completing the Getting Started Wizard

2 Connecting the Ethernet Cables
3 Installing the Capacity License
4 Taking Next Steps
To complete the DXi6902 Getting Started wizard:
1 On the service laptop, open a supported Web browser, type 10.17.21.1 in the
Address box, and press <Enter>.
The Login window displays (see
Note: For Web browsers, the DXi6902 supports Firefox 10 or higher, Chrome 21
or higher, or Internet Explorer 8, 9, 10, or 11.
Note: If the Login window does not display, verify that you entered the correct IP
address (10.17.21.1). Also make sure that the service laptop is connected
to the service port on the Node, and that the network settings on the
laptop are correct (see
minutes, then try again.
Figure 41).
Accessing the Service Menu
DXi6902
on page 35). Wait ten
45