Replication Configuration - Quantum DXi4700 User Manual

Chapter 9: Configuration

Replication Configuration

To configure Accent:
1. To enable Accent, select the Enable Deduplication with Accent check box.
To disable Accent, clear the Enable Deduplication with Accent check box.
2. Click Apply.
Additional Information
Click the Change Encryption Type link to change the OST data encryption type (see
l
Encryption on page
To use DXi Accent, you must install the Quantum OST Client Plug-in on the media server.
l
Replication Configuration
The Replication Configuration page allows you to configure and manage replication targets and allowed
replication sources on the DXi4700. A source sends replicated data to 1 or 2 targets, and a target receives
replicated data from up to 10 sources. A DXi4700 can act as both a source and a target.
Additional Information
For more information about data replication, or to perform data replication, see
l
page 122.
If the DXi is configured as a replication target and replication is performed across a public network,
l
with the source and target located behind NAT-enabled routers, you must specify a NAT IP address
for the DXi on the Network page (see
To access the Replication Configuration page, click the Configuration menu, and then click the
Replication tab (see Figure 159
Figure 159: Replication Configuration Page
Quantum DXi4700 User's Guide
315).
Configuring Interface IP Addresses on page
below).
Data
Replication on
295).
253