5.1.5 Dial Tone
PC Programming Manual References
9.25 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
→
Dialing Mode
→
DTMF Width
→
Pulse Speed
5.1.5 Dial Tone
Description
The following dial tones inform extension users about features activated on their extensions:
Each dial tone type has two frequencies, such as dial tone 1A and dial tone 1B.
Type
Tone 1A/1B
Tone 2A/2B
Tone 3A/3B
Tone 4A/4B
Conditions
•
Dial Tone Type A/B
Through system programming, it is possible to select dial tone type A or B for dial tones 1 through 4. If
"Type A" is selected, all dial tones 1 through 4 will become dial tone type A.
The dial tone type for the ARS feature can be selected separately. If "Type A" is selected for ARS, dial
tone 1A will be heard. If "Type B" is selected, dial tone 1B will be heard.
•
Dial Tone Patterns
All dial tone patterns have a default (® 23.2 Tones/Ring Tones).
•
Only dial tone 1 is sent to the extensions in a VM (DPT/DTMF) group.
92
Feature Manual
A normal dial tone is heard when:
a.
No features listed for dial tones 2 through 4 has been set, or
b.
Automatic Route Selection (ARS) is used.
This tone is heard when:
•
Any of the features below are set.
•
Absent Message
•
BGM
•
Call Forwarding (FWD)
•
Call Pickup Deny
•
Call Waiting
•
Do Not Disturb (DND)
•
Extension Dial Lock
•
Executive Busy Override Deny
•
Hot Line
•
Timed Reminder
This tone is heard when:
•
A called PS is being searched for.
•
Any of the features below are performed.
•
Account Code Entry
•
Consultation Hold
•
Answering a Timed Reminder call with no message
This tone is heard when new messages have been recorded for the
extension.
Description
Document Version 2016-03