Ps (Portable Station) - Panasonic KX-NS1000 Feature Manual

15.1.24 PS (Portable Station)

Installation Manual References
4.4 Virtual Cards
PC Programming Manual References
9.12.2 PBX Configuration—[1-1] Configuration—Slot—Shelf Property - Virtual IP Gateway—Hunt Pattern
9.13 PBX Configuration—[1-1] Configuration—Slot—V-IPGW16—Port Property
17.1 PBX Configuration—[9-1] Private Network—TIE Table
18.4 PBX Configuration—[10-5] CO & Incoming Call—Miscellaneous—
No Destination (Destination is not programmed.)
Feature Manual References
2.1.3 ARS (Automatic Route Selection)
15.1.12 PRIVATE NETWORK FEATURES
15.1.24 PS (Portable Station)
Description
A Panasonic portable station (PS) can be used in place of a proprietary telephone (PT), providing wireless
access to PBX features and call handling.
Cell Stations (CSs) allow PSs to receive reception within a designated area.
1.
Registration
Before a PS can be used, it must be registered with the PBX through system programming and assigned
an extension number.
® 9.30 PBX Configuration—[1-2] Configuration—Portable Station—PS Registration and
De-registration—
Because a PS transmits radio waves, it is possible that a PS belonging to a neighboring PBX can be
registered to your PBX. To prevent this sort of unauthorized registration, a personal identification number
(PIN) can be programmed for this PBX that must be entered on the PS during registration. This PIN, if
programmed, is only used during the PS registration process.
® 9.30 PBX Configuration—[1-2] Configuration—Portable Station—PS Registration and
De-registration—
Each PS can be registered to more than one PBX if necessary, and registration can be canceled if a PS
will no longer be used with one of these PBXs.
® 9.30 PBX Configuration—[1-2] Configuration—Portable Station—PS Registration and
De-registration—
2.
Connection
There are two ways a PS can be used.
As an Extension
A PS is assigned its own extension number when it is registered to a PBX. The PS can use this extension
number to make and receive calls, just as a wired telephone can. A PS can be a member of an incoming
call distribution (ICD) group, can be assigned as the destination for redirected calls, etc., just as a wired
telephone can.
A PS can also be a member of a PS ring group (® 15.1.27 PS—Ring Group). A PS ring group is a way
for several PSs to be notified of an incoming call simultaneously, but does not offer all of the features
provided by an ICD group. (® 10.1.1 ICD GROUP FEATURES)
In Wireless XDP Parallel Mode
322 Feature Manual
Registration
Personal Identification Number
De-registration
Intercept—Routing to Operator -
Document Version 2016-03