Dhcp (Dynamic Host Configuration Protocol) Server; Dial Mode Selection - Panasonic KX-NS1000 Feature Manual

5.1.3 DHCP (Dynamic Host Configuration Protocol) Server

Description
The PBX has a built-in DHCP server. When the DHCP server is enabled, the PBX will automatically assign IP
addresses to other devices on the network, such as IP-PTs.
Using a DHCP server simplifies network management by removing the need to assign IP addresses to devices
manually.
Conditions
•
The DHCP Server feature cannot be used if the PBX's IP address assignment mode is set to DHCP.
•
If the PBX's DHCP server is enabled, make sure that no other DHCP servers are running on the same
network. Having more than one DHCP server on a network can result in network errors.
•
For the following settings, the PBX delivers the settings of its LAN port to devices: subnet mask, default
gateway address, and DNS server addresses. As NTP server information for KX-UT extensions, the PBX
delivers its own IP address.
PC Programming Manual References
28.2.1 Network Service—[2-1] Server Feature—DHCP

5.1.4 Dial Mode Selection

Description
The dialing mode (rotary or tone) can be selected for each analog CO line through system programming
regardless of the originating extension (under contract with the telephone company).
Mode
DTMF (Dual Tone
Multi-Frequency)
Pulse Dial (Rotary)
Conditions
•
Pulse to Tone Conversion
It is possible for an extension user to temporarily switch from Pulse mode to DTMF mode in order to access
special services such as computer-accessed long distance calling or voice mail services. To switch to
DTMF mode, wait for a preprogrammed time period (Default: 5 seconds) after the CO line is connected,
or press . This feature works only on CO lines set to Pulse mode. DTMF mode cannot be changed to
Pulse mode.
•
It is possible to select a pulse rate for the CO line port which has been set to Pulse mode. There are two
pulse rates: Low (10 pps) and High (20 pps).
•
It is possible to assign the minimum duration of the DTMF signal sent to the CO line port which has been
set to DTMF mode.
Document Version 2016-03
Numbers dialed by an extension user are transmitted to the CO line
using analog tones.
Numbers dialed by an extension user are transmitted to the CO line
using analog pulses.
5.1.4 Dial Mode Selection
Description
Feature Manual 91