19.1.6 Trunk Adaptor Connection
19.1.6 Trunk Adaptor Connection
Description
IP CO lines (V-SIPGW and V-IPGW) can be connected to a Trunk Adaptor (KX-NS8290), which allows the
KX-NS1000 to connect to PRI lines.
Conditions
[General]
•
One IP CO line port corresponds to 1 channel in the Trunk Adaptor.
•
An activation key is not required for ports whose Connection Attribute setting is set to Trunk Adaptor.
Ports without this setting can still be connected to a Trunk Adaptor, but they will require an activation key.
•
One KX-NS1000 can connect to multiple Trunk Adaptors.
•
In a One-look network, the channels of a PRI line can be divided among multiple KX-NS1000 PBXs.
•
For details about configuring settings for PRI lines, refer to the documentation for the Trunk Adaptor.
[Connection via SIP CO Line]
•
The SIP CO line authentication ID and the authentication ID of the IP interface on the Trunk Adaptor must
be the same.
•
The channel attribute of SIP CO lines connecting to a Trunk Adaptor must be set to Basic channel.
PC Programming Manual References
9.11 PBX Configuration—[1-1] Configuration—Slot—V-SIPGW—Port Property—Programming Port
Properties—Trunk Adaptor
9.11 PBX Configuration—[1-1] Configuration—Slot—V-SIPGW—Port Property—Main
→
Connection Attribute
→
Channel Attribute
9.13 PBX Configuration—[1-1] Configuration—Slot—V-IPGW16—Port Property
→Trunk Adaptor
→
Connection Attribute
384
Feature Manual
Document Version 2016-03