Connect The Network Cables; Connecting A Fiber Cable; Connecting A Copper Cable - HP ProCurve 6400cl Installation And Getting Started Manual

Installing the Switch
Installation Procedures

7. Connect the Network Cables

Connect the network cables, described under "Cabling Infrastructure"
(page
copper ports on the switch.

Connecting a fiber cable

To connect:
1. Remove the dust covers from
2. Aligning the notches on the
If the Link LED does not go on
when the network cable is
connected to the port, see
"Diagnosing with the LEDs" on page
To disconnect:
Pull the cable connector straight out.

Connecting a copper cable

To connect:
1. Push the copper cable
To disconnect:
Pull the cable connector straight
out.
When a network cable from an
active network device is connected
to the port, the port LED for that
port should go on. If the port LED
does not go on when the network cable is connected to the port, see
"Diagnosing with the LEDs" on page 4-3
2-14
2-5), from the network devices or your patch panels to the fiber or
the cable connectors and the
port.
cable connectors with the slots
of the port, press the cable
connector into the port until it
snaps into place.
connector into the copper port.
Ensure the locking device locks
the cable connector into place.
2
4-3, in chapter 4, "Troubleshooting".
in chapter 4, "Troubleshooting".
1