Connecting The Switch To The Lan - HP StorageWorks 2/16 - SAN Switch Installation Manual

Connecting the Switch to the LAN

Execute the following procedure to connect the switch to the Ethernet Local Area
Network (LAN) segment.
1. Remove the shipping plug from the Ethernet port.
2. Connect one end of an Ethernet cable to the Ethernet port, see
Figure 15: Connecting the Ethernet cable
3. Connect the other end of the Ethernet cable to the workstation or to an
Note:
Telnet or the Web Tools application. Verify that the switch is not accessed from any
other connections during the remaining steps.
4. Log in to the switch with administrator privileges by Telnet. The default
SAN Switch 2/16 Version 3.1.2 Installation Guide
Ethernet network containing the workstation.
You can now access the switch remotely (and from multiple connections), using
administrator logon is admin and the default password is password.
Installing the SAN Switch 2/16
Figure
SHR-2550A
15.
43