Installing the SAN Switch 2/16
Checking POST Results
Check the success/fail results of the diagnostic tests run during POST via LED
activity, the error log, or Command Line Interface (CLI) using the errShow
command. For more information about error messages, refer to the HP
StorageWorks Fabric OS Version 3.1.x/4.1.x Reference Guide.
Configuring Network Addressing
Read the following sections for information on how to configure addressing for
the switch.
Requirements
The following items are required to set network addressing.
58
An IP address from your Network Administrator
The switch installed and connected to a power source
Serial cable (supplied with the switch) for connecting the switch to the
workstation
A local workstation (desktop or notebook computer) with:
®
— Microsoft
Windows 98, Windows
®
or Windows NT
— RS-232 Serial communication software (for example, ProComm Plus or
HyperTerminal)
Ethernet cable for connecting the switch to the workstation or to a network
containing the workstation
SFPs and cables, as required to connect the switch to the fabric
®
2000, Windows Millennium Edition,
4.0 operating system
SAN Switch 2/16 Version 3.1.x Installation Guide