Mitsubishi PLK-E Series Technical Manual page 77

Methods of creating stitching data
Deflection width, feed amount and creation direction
Feed amount
Memo When the direction of making is made
"Center"
zigzag pattern data if "Width of the
shake" is 0.1mm.
Please set "Width of the shake" to
0.2mm or more, or whether to do the
direction of making is other then
"Center"
3. Setting the back tacking details
, does not become a
.
Travel direction right side
Travel direction left side
Travel direction center
* After returning to the Input Method
Setting screen, press the back Tacking
Details
Setting key .
* The details are set on this screen.
(The details set here are,
overlap
mode , three overlap stitches.)
* After inputting the details, press
to set the data.
* The system will return to the input
method setting screen.
* Press to determine the set
values.
,