Mitsubishi PLK-E Series Technical Manual page 120

Designating the modification position without using jog keys
data.)
Steps 1 to 3 are the same as for designating the modification position with the jog keys. Steps 4 and
following are explained below.
4. Determining the block modification range
5. Moving and determining the modification position
6. Confirming the data creation
[12]-32
* Using Jog
the start point(B point) and end
point(E point).
* Press Jog Validity
* Press
When the end point is determined, the
work holder will automatically return
to the start point. Take care when the
needle is lowered, etc.
* Using the arrow keys, modify the
position. (Move to C' point in this
example.)
* Press
* If there are several positions to be
modified, repeat step 5. The number
of input points will increase.
(In this example, modify the D' point in
the same manner.)
* When all modifications have been
made, press
* To create the data, press
(The block position will be modified.)
The work holder will automatically
return to the start point. Take care
when the needle is lowered, etc.
Modification mode
(Handy for newly creating
, , determine
.
.
.
again.
.