Mitsubishi PLK-E Series Technical Manual page 47

6. Completing circle input
7. Inputting the return/end code
8. Confirming the data
Methods of creating stitching data
[9]-9
* Press
* Press
(Data on feed data to the home position
and the end code will be created.)
The work holder will automatically return
to the home position. Take care when
the needle is lowered, etc.
* A prompt for home position return will
appear.
Press
The needle will rise to the UP
position.
If the needle is not at the UP position,
it may lower once and then return to
the UP position
* A message indicating that the data is
being created will appear, and then
the Standard panel will reappear.
* Confirm the data.
Press the jog keys (
so the sewing machine movement can
be confirmed. (Even if the data input
has not been completed, if the data
input last has been set, the movement
can be confirmed in the same
manner.)
* If the confirmed data is correct, save
the data. (Refer to [5] Reading, writing
and erasing data (floppy disk) and [6]
Reading, writing and erasing data
(internal memory).)
* If the data must be modified, refer to
section [12] Modification mode
Modifying the stitching data.
.
.
.
),