Mitsubishi PLK-E Series Technical Manual page 157

3. Selecting overlap back tacking
4.Setting the back tacking details
5. Confirming execution of conversion
[13]-7
* Press overlap back tacking
[Memo] If the selected block is a
"closed figure", the overlap
back tacking key will also
appear. (Selection will be
enabled.) This is displayed in
this example. (Selection is
possible.)
* The details are set on this screen.
(The details set here are,
(overlap back tacking), overlap
mode
* Press
* Quit the modification mode.
Press
screen.
(When
the modifications executed last will be
undone.)
Data conversion mode
.
, three overlap stitches.)
.
to return to the Standard
is pressed,