Modifying Code Data (Adding Code Data) [12]-52 - Mitsubishi PLK-E Series Technical Manual

Modification mode
(23) Modifying code data (Adding code data)
[Memo] Refer to "Inputting code data" for a list of code data.
[Example] The needle UP halt code (USTP) will be added to the D point of the following type of stitching
data.
Operation details
1. Selecting code data addition
2. Determining the code addition position
* Enter the modification mode. (Refer to
the methods for entering the
modification mode.)
* Press Code Data Change
then press Code Data Add
* Press
* Using Jog
the position to add the code.(D point)
* Press
the position.
[12]-52
,and
to open the next screen.
, , determine
after determining