Mitsubishi PLK-E Series Technical Manual page 154

3. Selecting start/end back tacking
4.Setting the back tacking details
5. Confirming execution of conversion
Data conversion mode
* Press start/end back tacking
[Memo] If the selected block is a
"closed figure", the overlap
back tacking key will also
appear. (Selection will be
enabled.) This is not displayed
in this example. (Selection is
not possible.)
* The details are set on this screen.
(The details set here are,
(start/end back tacking)),
start mode (N mode), five
start
stitches, end mode
three end stitches.)
* Press .
* Quit the modification mode.
Press to return to the Standard
screen.
(When is pressed,
the modifications executed last will be
undone.)
.
(M mode),