Modifying A Block 3 (Zigzag Input) [12]-35 - Mitsubishi PLK-E Series Technical Manual

(17) Modifying a block 3 (Zigzag input)
The section between the A point and B point in the following type of stitching data is modified to a
zigzag pattern.
Operation details
1. Selecting block modification
2. Selecting the input type
* Enter the modification mode. (Refer to
the methods for entering the
modification mode.)
* Press Stitch Data Change
Block Modify
* Press
* Press Zigzag
* Set the deflection width, feed amount
and creation direction.
Set the deflection width to 5.0mm,
feed amount to 3.0mm, and the
creation direction to right (R).
[Memo] Refer to "[9] Methods of
creating stitching data (12)Zigzag
stitching (with overlap back tacking)"
for details on the deflection width,
feed amount and creation direction.
* Press
(* At this time, if
the deflection width and feed amount
settings will be canceled.)
[12]-35
Modification mode
and
.
to open the next screen.
.
to set the data.
is pressed,