Mitsubishi PLK-E Series Technical Manual page 67

3. Confirming the data
Memo Overlap mode
Memo Number of overlap stitches
This is the number of stitches at the overlapped section. (Set a value between 0 and 9.)
Memo
If the distance between the broken line start point and the end point is 0.5 mm or more, the
overlap back tacking data will not be created.(If the distance between the broken line start point
and the end point is less than 0.5, the pattern will be regarded as the "closed pattern", and the
same coordinate value will be automatically set for both the start point and end point.)
* After creating the broken line data,
[9]-29
in the overlap mode indicate the number of overlapped sections.
Methods of creating stitching data
input .
* The overlap back tacking will be
created with the rectangle made with
broken lines.