6. Moving from the modification origin jog position to the modification
position, and setting the data
7. Quitting position modification
8. Confirming the data creation
* Press the arrow keys and modify the
position. (Move to the C' point in this
example.)
* If there are several positions to be
modified, repeat steps 5 and 6. The
number of input points will increase.
(In this example, move from the D
point to the D' point in the same
manner.)
* Press
The work holder will automatically
return to the modification origin jog
position (Needle position specified at
(5.)). Take care when the needle is
lowered, etc.
* After determining all modification
positions, press
* To create the data, press
(The block position will be modified.)
The work holder will automatically
return to the start point. Take care
when the needle is lowered, etc.
[12]-31
Modification mode
.
.