3. Determining the block modification range (end point)
4. Setting the movement method and stitch length
5. Determining the movement amount
[12]-20
* Using Jog
the end point position.
* Press
When the end point is determined, the
presser will automatically return to the
start point. Take care when the needle
is lowered, etc.
* Set the movement method.
Press Prior/Subsequent Data
Change
* Set the stitch length.
(Set to 3.0mm for this example.)
* Press
* Using the arrow keys, determine the
movement amount.(Move to the
position (point D').)
* Press
(The block position will be modified.)
The work holder will move. (The work
holder will return to the start point of the
section being modified; in this case the
start point (A point) of the broken line
input.) Take care when the needle is
lowered, etc.
Modification mode
,
, determine
.
.
.
.