Table of Contents
Advertisement
Home position/encoder/detector confirmation
The status of the home position and encoder detector is displayed in an
easy-to-read format.
Input setting (Custom input) ［ Password function ］
1. Input Customize Setting screen
2. Function Selection screen
3. Details Setting screen
* The detector angle is the angle from the detected
DOWN position.
* The encoder color will be alternately highlighted.
This means detection.
This means non-detection.
[Memo] Each display might be concealed by the error
message's giving priority according to the situation
and being displayed. The magnetic of pulls motor is
released when entering this mode. When the
starting point return/the drive signal enters, the
magnetic of pulls motor is turned on again.
Be careful! The sewing machine is ready
for operation.
* Press the physical input RAM (I1 to I9, IA to IP) to
be customized. The Function Section screen will
open.
* Press the
type.
(In this case, "SRT" is selected.)
(Refer to (3) Input signal setting table for details
on the signal types.)
* To make detailed settings, press the "Details
setting" key.
* Change the logic of the input signal.
(Normal/reversed)
* Change the operation of the input signal.
(Normal/alternate)
* Press the
to fix the setting.
(The previous screen will open.)
[Memo] Refer to [Control unit section] [10] Block
diagram and operation explanation for details
on the signal logic and operation.
[15]-3
Input/output setting mode
keys and select the signal
Hide quick links:
Advertisement
Table of Contents
