Mitsubishi PLK-E Series Technical Manual page 124

Modification mode
3. Determining the block modification range (start point)
4. Determining the block modification range (end point)
5. Confirming the data creation
* Using Jog ,
the start point position.(A point)
* Press .
* Using Jog ,
the end point position.(B point)
* Press .
When the end point is determined, the
work holder will automatically return
to the start point. Take care when the
needle is lowered, etc.
* To create the data, press
(The block position will be modified.)
The work holder will automatically
return to the start point. Take care
when the needle is lowered, etc.
, determine
, determine
.