Mitsubishi PLK-E Series Technical Manual page 164

Data conversion mode
3. Setting the center position
4. Confirming execution of conversion
* In the jog mode, move to the
needle near the desired
enlargement/contraction center.
(In this case, move to point A that
is near point A'.)
* Press .
[Memo] The center point can be
designated without using the jog
keys.
In this case, press only
* If the center point is not to be set
on the stitching data, use the
arrow keys and move to the
position to be used as the center.
(A' point)
* After moving to the desired center
position, press
Memo If the desired center
position is on the pattern data, do
not move using the arrow, but
just press .
* Press .
.
.