3. Determining the block modification range (start point)
4. Determining the block modification range (end point)
5. Confirming the data creation
[12]-26
* Using Jog
the start point position.(A point)
* Press
* Using Jog
the end point position.(B point)
* Press
When the end point is determined, the
work holder will automatically return to
the start point. Take care when the
needle is lowered, etc.
* Press
(The block position will be modified.)
The work holder will automatically
return to the start point. Take care
when the needle is lowered, etc.
Modification mode
,
, determine
.
,
, determine
.
.