Mitsubishi PLK-E Series Technical Manual page 129

Modification mode
6. Moving from the modification origin jog position to the
modification position, and setting the data
7. Quitting position modification
8. Confirming the data creation
[12]-39
* Press the arrow keys and modify the
position.
(Move to the E' point in this example.)
* Press
* If there are several positions to be
modified, repeat steps 5 and 6. The
number of input points will increase.
(In this example, move from the F
point to the F' point in the same
manner.)
The work holder will automatically return
to the modification origin jog position.
Take care when the needle is lowered,
etc.
* After determining all modification
positions, press
* Press
(The block position will be modified.)
The work holder will automatically
return to the start point. Take care
when the needle is lowered, etc.
.
.