Table of Contents
Advertisement
3. Setting the center position
4. Confirming execution of conversion
* In the jog mode, move to the
needle near the desired center.
* Press
[Memo] The center point can be
used without using the jog keys.
In this case, press only
* If the center point is not to be set
on the stitching data, use the arrow
keys and move to the position to be
used as the center.
* After setting the center, press
Memo If the desired center
position is on the pattern data, do
not move using the arrow, but
just press
* Press
[13]-18
Data conversion mode
.
.
.
.
.
Hide quick links:
Advertisement
Table of Contents
