Mitsubishi PLK-E Series Technical Manual page 31

Creating simple stitching data
5. The Data Input menu will open.
6. A prompt for home position return will appear.
7. The Standard screen will open.
[Memo] Stitching can be started, but the created input data is not saved in this state. Refer to the
following sections for details on saving the data.
[5] Reading, writing and erasing data (floppy disk)
[6] Reading, writing and erasing data (internal memory)
[8]-2
* When
holder will return to the home position,
and inputting of data will be
completed.(Data on feed data to the
home position and the end code will be
created.)
The work holder will automatically return
to the home position. Take care when
the needle is lowered, etc.
* Press
The needle will rise to the UP position.
If the needle is not at the UP position, it
may lower once and then return to the
UP position.
* A message indicating that the data is
being created will appear. Wait for a
moment.
* Return to the Standard screen and
confirm the input data.
* This completes the input
is pressed, the work
.