Table of Contents
Advertisement
LX9000 Version 2.6
8
Installation
The LX9000 digital unit is installed in an aperture with dimensions 143 mm x 109 mm. The
V5 vario unit and any additional vario indicators each require a standard 57 mm cut-out.
Three pressure connectors are fitted to the back of the V5 vario unit. A label shows their
functions.
•
P
means static pressure connector.
static
•
P
means pitot or total pressure connector.
total
•
TE means total energy TE connector.
If the unit is to be configured for electronic TE compensation the connections are as follows:
•
P
Static
static
•
P
Pitot or Total pressure
total
•
TE/P
Static
static
If the unit is to be configured for pneumatic TE compensation using a TE tube, then the
connections are:
•
TE/P
TE tube
static
•
P
Static
static
•
P
Pitot or Total pressure
total
If the P
total
integrator reading (average climb) during the flight.
The LX9000 digital unit is connected to 12 Volt power via the 15-pin SUB-D connector. The
LX9000 digital unit and the vario unit (57 mm units) are connected via the RS485 bus and
the connectors are labelled with "1" at each end.
Please ensure that both units are connected correctly before the first power on. The power
wires (red and blue) should be connected to the main LX9000 digital unit.
and Static are connected the wrong way around there will be no
Page 106 of 130
September 2011
Advertisement
Table of Contents
