Trace Display States (Sa Mode) - Keysight FieldFox A Series User Manual

SA (Spectrum Analyzer) Mode
SA Mode Settings

Trace Display States (SA Mode)

In SA Mode you can display up to four of the following types of trace states. All
SA settings are applied to all displayed traces.
and SA Mode)" on page
A color-coded legend for displayed traces is visible in the left pane of the SA
mode screen:
W = Clear/Write; M = MaxHold; m = MinHold; A = Average; V = View
How to display the Trace States
— Press Trace 6.
— Then
— Then
— Then choose from the following Trace States:
— Press
Trace 4 data WILL be overwritten by the FieldFox when using the
Independent Source Normalize feature
Generator " on page
corrections
178
488.
Trace 1,2,3,4 repeatedly to select a trace number to display or change
its state. Traces are displayed in the following colors:
— Trace 1 – Yellow
— Trace 3 – Orange
State [current setting]
—Clr /Wr (Clear/Write) Displays the actual measured data for each
sweep.
—MaxHold Displays the maximum response of the input signal at each
data point over multiple sweeps. See also Average Count in
Count" on page
—MinHold Displays the minimum response of the input signal at each
data point over multiple sweeps. See also Average Count in
Count" on page
—Average Each data point is averaged over multiple sweeps as set by
the Average Count setting. Learn more in
page 179.
—View Displays and then holds the last complete measurement trace on
the screen. This is similar to storing a trace in memory.
—Blank Displays no trace.
Default All to return all traces to their default settings: Trace 1
(Clear/Write); all other traces (Blank).
163) or using Field Strength antenna or cable
("Field Strength Measurements" on page
See also
Trace 2 – Blue
Trace 4 – Green
179.
179.
("Independent Source/Tracking
Keysight N9927-90001 User's Guide
"Marker Trace (IQA
"Average
"Average
"Average Count" on
156).